Marshalls Automotive: Cooling System

Keep Your Cool In Redmond

Redmond drivers rely on their car’s coolant system to keep their engine cool. Coolant (also called antifreeze) mixed with water flows through your vehicle engine and absorbs heat. The mixture then flows out to the radiator where it’s cooled by air flowing over the radiator. From there the coolant/water mix circulates back through the engine to absorb more heat.

There’s a reason we mix coolant and water. Water alone actually does a good job transferring heat from the engine. The problem is that water boils at a temperature that’s easily reached inside your vehicle’s engine, so it can turn to steam which does not conduct heat as well and is harder to contain.

Also, if it’s freezing outside in Redmond, the water in your engine could freeze while your vehicle is sitting out in the cold.

So, if you remember your Redmond high school chemistry, you’ll know that a mixture has both a higher boiling point and a lower freezing point than either component alone.

Coolant, or antifreeze, is specially formulated to keep your engine safe in a wide range of environmental and operating temperatures in and around Redmond.

Whenever the vehicle is running, the coolant in the cooling system is working to keep your engine from overheating. When it’s cold outside, the coolant acts as antifreeze to keep the fluid from freezing in your engine.

All that exploding fuel in your engine creates a lot of heat. Without coolant, the metal vehicle engine parts would expand so much that the engine would seize up and stop running. Expensive parts could be broken or warp so badly they would have to be replaced. It could even be so bad that the whole vehicle’s engine is ruined and has to be junked.

This is why it is critical that Redmond drivers check coolant levels frequently and have their vehicle cooling system inspected for leaks. Also your vehicle manufacturer has a maintenance requirement for draining and replacing your coolant. These recommendations can vary widely, so check your owner’s manual or ask us at Marshalls Automotive in Redmond.

The reason you need to change the coolant is that it has additives in it to protect the cooling system. As you can imagine, with all the heat, the cooling system’s a pretty harsh environment. The additives keep the fluid from becoming corrosive and damaging the radiator and other vehicle cooling system components. Over time, the additives are depleted and the coolant just has to be replaced.

Many Redmond auto owners ask Marshalls Automotive why there are different colors of antifreeze. It is very important that you use the correct type of antifreeze. The different types of antifreeze – or coolant – are different colors so you don’t mix them up.

Auto manufacturers use different materials to make the cooling system, and they require different types of antifreeze to protect them.

So check with us at Marshalls Automotive or your owner’s manual for the right kind because using the wrong coolant can void the warranty for your vehicle cooling system.

Marshalls Automotive Radiator Service

The coolant system is a vital part of your vehicle. It is also the second most common cause for vehicle failures. Even though coolant system failure is fairly common, it is easy to prevent.

Marshalls Automotive
2110 S Highway 97
Redmond, Oregon 97756
541-548-5239

The most recognizable part of the coolant system is the radiator. It is connected to the engine with hoses and is filled with coolant. The coolant draws heat off the engine and then goes into the radiator. Air passes through cooling fins to reduce the temperature of the coolant and then it’s back to the engine again.

There are several ways for the cooling system to fail. Most common is with the coolant itself. Coolant is a mixture of water and antifreeze. The proper mixture keeps the coolant from either boiling away or freezing. Both of which can result in massive engine damage.

Another very important coolant issue that is often overlooked is the age of the coolant itself. Antifreeze has additives that protect the coolant system from corrosion. As these additives are depleted over time, they can’t protect the radiator and other parts from rust, scaling and corrosion. Old coolant may still keep your engine cool, but it won’t protect it from corrosion.

If you see a warning message to check the coolant or if the temperature gauge is in the hot zone your cooling system needs to be checked. It’s OK to add water or antifreeze yourself. But you need to be cautious. Remember four things.

• First, you never want to open the radiator pressure cap. You could be severely burned.
• Second, try to get to your Redmond service center at Marshalls Automotive immediately if your coolant is low. If that is not possible, follow the directions in your owners manual – it will direct you to only make additions to the coolant overflow bottle.
• Third, remember that you need a proper mixture of water and antifreeze. If you make an emergency addition to your cooling system, follow-up with your Marshalls Automotive service center where we can make necessary corrections.
• Fourth, not all cars use the same type of antifreeze. You need to check your owners manual to make sure you use the right kind. Mixing antifreeze types or using the wrong kind of antifreeze may void the manufacturers warranty on your cooling system. Again, another reason to rely on your Marshalls Automotive service center in Redmond to do things right.

Remember, your Redmond service center has the equipment to change your coolant quickly and inexpensively.